|
Setup Parameters of Receiving microwave : SETUP PARAMETERS : Set special funcions of microwave (switch on/off, normal or test mode, force disqualification, battery connection etc) · FREQUENCY : Set the frequency that the microwave must read from the transmitter I · DELAY TIME : Set the delay time for MW calibration · SENSITIVITY : Set the sensitivity (1/99) for MW calibration LOAD button allows to charge previously saved configuration |
|
Diagnostic parameters on receiving microwave : The window is divided in Three sectors : · STATUS : Show the actual status of the microwave. · SETUP : Shows how the user has configurated the microwave from the setup window · ANALOG VALUES : Shows in real time the analogic parameters of the microwave. The user has the possibility to save periodically the status of the microwave on a txt file, trough SAVE button (see manual). He can also store only during the alarms, to see the changes. On bottom-left part are shown delay time and sensitivity set by user |
|
MW RX MANAGE |
|
STATUS |
SETUP |
ANALOG VALUES |
|
RESTART : microwave is restarting |
RX OFF : microwave swtiched on or off |
FREQUENCY : Channel 1 : 900Hz +/5%, Channel 2 : 1150Hz +/- 5%, Channel 3 : 1500Hz +/- 5%, Channel 4 : 2400Hz +/- 5% |
|
ERROR : Generic Trouble on microwave electronic |
TEST : Microwave is set in test mode, with AGC functions blocked |
INPUT VOLTAGE : 0,7V +/- 5% |
|
SUPPLY ERROR : 12V power supply out the correct range |
LOW SENSIVITY : Microwave forced to work in low sensitivity mode |
REFERENCE VOLTAGE : 1,7V +/- 5% |
|
BATTERY ERROR : Low power supply on the battery |
BALANCED INPUT : shows that the user has activate the hardware input for forcing the sensitivy reduction |
ANALOG SUPPLY VOLTAGE : ca SUPPLY VOLTAGE- 5% |
|
DISQUALIFICATION : Microwave works in low sensitivity mode, through sense hardware input |
UP-DOWN TEST : shows that up-down test function is active |
SUPPLY VOLTAGE RANGE : 11V < V < 13.6V |
|
INTERFERENCE : Microwave have some interferences from external sources. Verify |
BATTERY CONNECT : show that the user has set up a battery connection |
BATTERY VOLTAGE RANGE : Must have sufficient power to recharge the connected battery |
|
WRONG FREQ : Transmitter and receiver microwave have different channels set. |
|
AGC : from 0% to 99%, top working range after alignment 15%<AGC<25% |
|
ALARM : The microwave has detected something crossing its |
|
ALARM DELAY TIME VALUE : Last alarm delay time (> 15ms) |
|
|
|
ALARM SENSITIVITY VALUE : Last mass % detected. 1/99% according to MW set sensitivity |